Shopping Cart

Your cart is empty.

Your cart is empty.

MOOG K6472 Rack and Pinion Bellows Kit for Buick LeSabre

Free shipping on orders over $29.99

$18.75

$ 8 .99 $8.99

In Stock
  • By constantly introducing design enhancements that extend product life and simplify installation and replacement, MOOG has earned its reputation as the chassis industry's Problem Solver.
  • Easy to install
  • Manufactured using premium materials
  • Engineered to provide long life and dependability
  • Construction and design validated by MOOG engineers
  • Incorporates proven design and engineering features


Moog Problem Solver products incorporate proven design and engineering features for like new steering, ease of installation and longer life. Moog is the preferred steering and suspension brand of professional technicians and NASCAR Crew Chiefs.


JJ
Reviewed in the United States on July 7, 2024
Does not fit a 2010 Buick Lucerne, big end is too small.
Customer
Reviewed in the United States on September 17, 2023
Replaced the rack bellows, left side of my 2002 Buick Lesabre when replacing the CV joint. My steering rack bellows was completely rotten, and this Moog part made it like new again. The largest diameter end would not go on the aluminum rack - the bellows was a bit too small. At first, I thought it just wasn't going to work. So, I heated the large end with a hair dryer (off the car) and forced it onto a funnel such that the bellows diameter while hot and more flexible was increased a small bit. Then I was able to get it on the aluminum bore of the rack and placed the plastic tie that was provided with kit. Without doing this I believe it would have been futile to get it to fit on the rack in such tight quarters.
Bryan C. Burns
Reviewed in the United States on September 23, 2022
Installed on a 2004 Buick LeSabre. Works well
rachel rogers
Reviewed in the United States on July 23, 2022
Large end was too small for my 2007 Buick Rendezvous.Also the threadlike zip ties don't really seem sufficient to replace the OEM crimp ring that held the original boot on.
DaDa
Reviewed in the United States on April 13, 2021
Worked fine on the deville. Be sure to add a little grease to the tire rod arm to assist in sliding new bellow on, also used blow dryer and applied heat to slightly create a bigger opening in the larger side, because it does have a tight fit.
Customer
Reviewed in the United States on April 25, 2019
If you are looking to replace the bellows on your 2000-2005 Deville, keep looking, this part will not fit. I'm not sure what this part DOES fit, but judging from the other review, it might not fit anything.
pranav2254
Reviewed in the United States on July 9, 2015
Does not fit the rack/tie rod on a 93-02 Camaro/Firebird well. The outer part of the boot will catch on the inner tie rod and tear apart. Went through two of these before getting a GM OEM part to solve the problem.