Your cart is empty.
Your cart is empty.Premium aftermarket replacement parts for Ford and Lincoln vehicles, Tested to provide performance and long-life reliability. labor included and no commercial exceptions.
xinaTX
Reviewed in the United States on June 19, 2021
Quality looks good. I used a trick I saw on YouTube where someone used an oil filter cap wrench to tap it in. Make sit it seats all the way but don’t bang it too hard or far. You’ll know by looking at it when it’s all the way in. I also put some grease on the inside and around the rubber
Doug Wertman
Reviewed in the United States on June 11, 2021
Perfect fit. I used a hockey puck and a hammer to install the seal. Worked great and snapped right in with no damage and a very snug fit.
rachael
Reviewed in the United States on November 3, 2021
Perfect fit for 09 f250
Fusty
Reviewed in the United States on October 30, 2021
Without using the special tool to press this on, it was a little challenging pressing this on, but I got it on. Time will tell how long it last. So 4 stars.
Rico
Reviewed in the United States on January 3, 2021
During a u joint replacement on the front of my 2017 F250 I replaced my plastic axel dust covers with these. Perfect fit! Just don’t over tap them in place or they may not stay as tightly secured.
X10Flux
Reviewed in the United States on December 27, 2018
A much better upgrade to what the factory installed when new.
J. Fiala
Reviewed in the United States on July 21, 2017
Amazon incorrectly lists this as a rear inner seal, but it is the updated front axle dust seal for a dana 60 (possibly others). Worked great on my 2008 F350 4x4.
SemperFi0505
Reviewed in the United States on March 28, 2017
Fit perfectly on my 2008 Ford F250. Just used one of my cups from the ball joint press to install it. Much better than the original style.
Recommended Products
