Your cart is empty.
Your cart is empty.Product Description
No Drill Front License Plate Holder, The Original Lockable License Plate Holder Fit for 2017-2023 Tesla Model 3/Y with Safety Design, No Adhesives License Frame
No Drill Front License Plate Holder
- Compatibility for 2017-2023 Tesla Model 3
- Compatibility for 2020-2024 Tesla Model Y
Shopaholic
Reviewed in the United States on March 30, 2025
I purchased the Tesla Y front license plate holder about a month ago and installed it per the instructions. It was easy to install and appeared to be fairly sturdy. However, after a month of driving, I noticed that the license plate was dangling crooked. I went to inspect it and found that the license plate frame was almost detached from the holder that attaches to the bumper where the grills are located. Evidently, 3 of the screws provided by the company had fallen off (probably due to the vibrations from driving the car). Only 1 screw was holding the plate frame in place and that screw was loose and was about to fall off. Had I not noticed the problem and had driven the car, the license plate would have fallen off and I would have lost the plate. The manufacturer needs to provide screws that lock in place or some other way to ensure that the screws do not come loose (maybe a longer screw with lock nuts). I had to find replacement screws for the 3 that were missing. I threaded them through and applied some Gorilla glue at the end of the screw so they wouldn't come loose.
Robin
Reviewed in the United States on March 24, 2025
Super well made! All metal parts. Easy to install and comes with a screwdriver. It also comes with keys just in case you need to take it off. I was a bit skeptical because it flagged this items as a frequently returned item but I couldn’t imagine an easier better product. It’s sleek and not bulky. It’s a bit cheaper than most other non screw mounts. Very pleased.
Priyanshu
Reviewed in the United States on March 24, 2025
Didn't wanna screw on my new tesla... this works like a charm
Ed and Shawn
Reviewed in the United States on March 20, 2025
Easy to install and stays on the front well.
mars hong
Reviewed in the United States on February 11, 2025
Easy install. Make sure to use some kind of thread locker
OmegaSR
Reviewed in the United States on January 20, 2025
Some folks complain that the item doesn’t fit. It isn’t easy to get in there. You have to bend your front care exterior to get it to fit. And that can be tricky too. You may need a screw driver to bend some areas so you can place it properly. The car exterior goes right back into place just fine if you do it right.Knocking off one star because it would’ve been nice if that whole bending my car exterior process was brought up front before purchase and with notes that I may have to temporarily warp my vehicle’s exterior in order to place it. Even better would’ve been if those locking mandibles could retract enough to make the bending not even required.
Oliver W.
Reviewed in Canada on January 18, 2025
Easy to install, lowest Highland plate holder. I don’t know how long it will hold up, but seems sturdy at the moment.
The K
Reviewed in the United States on April 12, 2025
Installed in a snap (5 minutes) . Make sure you have it latched to the steel bit inside the bumper.
Jerry M.
Reviewed in the United States on November 4, 2024
Easy to install and take off in seconds, but with a good security lock
Recommended Products