Your cart is empty.
Your cart is empty.Omix proudly offers a vast collection of OE quality replacement parts for Jeep & Willys vehicles to help keep the Jeep legend alive. This replacement inner axle oil seal fits 72-83 CJ5, 72-75 CJ6, 76-86 CJ7, 81-86 CJ8 Scrambler, 84-01 Cherokee XJ, 87-95 Wrangler YJ, 93-98 Grand Cherokee ZJ, 97-06 Wrangler TJ and 04-06 Wrangler Unlimited LJ models with Dana 30 27-spline front axles. Seal measures 1.125-inch ID and 2.132-inch OD. Sold individually- use 2 per axle. Replaces OE 8121781
Cole Larson
Reviewed in the United States on September 4, 2024
Don't count on hammer these into the case. You need the installation tool.
Jbizzy
Reviewed in the United States on August 19, 2024
I bought 3 and couldn’t get any of them to go into my Dana 30, buy a better seal. Pro torque is what i ended up with and they are far superior.
Wesley Weinzierl
Reviewed in Canada on August 7, 2023
THEY WORKING BUT DOESNT WORK GREAT WITH INNER SEAL INSTALLER FACTORY ONE WORK BETTER.HAD TO MAKE SOMETHING TO INSTALL SEALS.
Richard Taylor
Reviewed in the United States on August 13, 2023
These seals were a perfect fit and are working as advertised. Also had very fast delivery.
Quintin
Reviewed in Canada on July 15, 2023
Needed these and was working outside on the ground in the dark wasted an hour trying to get them in to find out there 2 thou too big
Zack
Reviewed in the United States on October 31, 2023
Works as expected. A bit of a pain to install but that just means it should make a tight seal.
Luigi Amato
Reviewed in Canada on October 19, 2023
I ended up buying OEM seals for 2003 Jeep tj axles. These ones were cheep and flimsy. Only one lip.
handfree
Reviewed in the United States on January 13, 2020
seem to be good quality ,time will tell.. installed them on jeep tj with dana 30 fit was good just keep straight when installing not to bend 36 mm socket worked as a punch inner axle seal front both sides about 3 hrs total from start to finish worth the work no more leak while you are there check them brakes ?
stingray13485
Reviewed in the United States on June 14, 2018
Went in fine, haven't tested them yet because my jeep isn't finished. Hopefully they will hold. They didn't seem real high quality but that remains to be seen
R. Miller
Reviewed in the United States on January 11, 2018
Bought two of these for my 06 TJ Dana 30 diff. I was installing a spartan "lunchbox" locker, so decided to replace the axle seals while I had the diff apart. I used a piece of pipe to punch out the old seals and cleaned out the axle tubes as much as possible. I cleaned up the area the seals seat and then started the reinstall. As some have mentioned they were a *very* snug fit. I ended up having to be a little creative to get them in. I placed the seal at the opening of the axle tube in the diff. Then I used a large socket and placed it over the seal while inserting a piece of pipe through the opposing axle tube and pressing on the socket. I basically pressed the new seals in by tapping on the pipe and driving them into place. I could have never pressed them in by hand and the angle was not right to really be able to tap them in with a rubber mallet or something like that. The seals went in and looked good, but I could understand why people would have trouble with them. I probably should have looked up a few youtube videos for tips, but luckily I got them in before I had to call for backup.
Ramsey
Reviewed in the United States on July 21, 2014
A+
Recommended Products
$34.18
$ 15 .99 $15.99