Your cart is empty.
Your cart is empty.Product Description
Speaker Cabinet Insert
From the Manufacturer
Fits on 1-3/8" stand and mounts into a speaker cabinet. On-Stage is a leader, changing the way musicians display, support, and protect their prized instruments and equipment. Music People proprietary product like On-Stage Stands and the others, Industry's most innovative stands and accessories.
Customer
Reviewed in Canada on February 6, 2025
remplacement dans une colonne de son (pièce endommagée)
Brandon
Reviewed in the United States on July 15, 2024
Exactly what it is suppose to be. I used this to replace a plastic one that broke in my speaker. Great price. Feels very sturdy. Seems like it will hold up.
Hans W. Gasterland
Reviewed in the United States on September 3, 2023
I bought the right size. And I had the right size holesaw. Easy Peezy.
GREG
Reviewed in the United States on December 20, 2023
Very sturdy material. Easy to install.
D Brooks
Reviewed in the United States on April 26, 2023
4 screw mount, steel...buy this one!Worked perfect, no Over-Play in the fitting of my 1" 3/8 " tripod stands. Not too tight either.Used mine for old Yamaha "Club Series III" 's PA/floor monitor combos
Nevada Geezer
Reviewed in the United States on March 15, 2021
Good quality, easy to install. Supplied with mounting screws.
FOM
Reviewed in the United States on March 13, 2021
Perfect fit for 1 1/2" stands. Super easy to install with an 1 5/8 - 1 3/4 hole saw and a screw gun.
Carlton Larsen
Reviewed in Canada on September 19, 2020
Great value on a solid steel piece. I have two now, and they are mounted on an acoustic guitar/vocal mice amp and a bass amp. Well built and inexpensive.
Abel Alvarez
Reviewed in the United States on January 27, 2020
Our church's Kustom speakers had plastic inserts, whiel moving around one cracked and broke through.bought these for cheap, super sturdy and easy to put on.
harlleyman
Reviewed in Canada on April 8, 2020
Good quality insert at decent price.
Shawn T. Eldridge
Reviewed in the United States on July 18, 2019
Just installed on a new PA speaker I built. 1.5" hole was a tiny bit snug, but worked OK with one small mod. Because it was so precisely fit, the welds on the inside of the base prevented the top hat from seating all the way down. I just seated it as far as I could, then used a piece of scrap wood to protect the bottom, and hit the base sharply with a hammer a couple of times. The welds dented the edge of the hole where they were interfering. Then I ran a drill bit (3/16-ish) on the edge where the dents were, knocking back the spots where the welds would be. Seated perfectly then.Other than that, fit the speaker pole well, seems like it will hold up fine. Make sure and measure your speaker pole diameter. There are at least two common sizes.
Vinnie
Reviewed in Canada on October 18, 2016
perfectly snug on my tripod stand
Recommended Products
$124.95
$ 53 .99 $53.99
$74.95
$ 33 .99 $33.99
$84.95
$ 38 .99 $38.99
$167.50
$ 82 .99 $82.99