Your cart is empty.
Your cart is empty.Product Description
Aluminum Shell Resistor Aluminum Housing Resistor Housed Case Wirewound Resistors Screw Tap Power Resistor
Advantage
The surface of the aluminum power resistor has cooling grooves, is small in size, has high-temperature resistance, and strong overload capacity, and can be used in harsh environments. The induction resistor has a solid structure and high stability for long service life.
Instruction
The aluminum-housed resistor is easy to install, and suitable for cooling plate installation. Connect the wires to the shafts on both sides, choose the appropriate size of the screw and install it on the hole.
NOTE
- The aluminum wire wound resistor will get hot when working, please do not touch it
- Axial load resistor should be mounted on metal board, please do not install it on flammable board.
Landon
Reviewed in the United States on February 13, 2025
Measured to 196 ohms. Good power resistors for the price 🙂.
paul williamson
Reviewed in the United Kingdom on July 18, 2024
Perfect
Robert W. Bacon Jr.
Reviewed in the United States on July 10, 2024
These resistors well suited for my projects. Good price and durable. Happy with purchase 👍
ve2mxo
Reviewed in Canada on February 9, 2024
La résistance de 200ohm 100Watts détruit l'isolant en la résistance et son boîtier. Elle dissipait seulement 72watts.
Customer
Reviewed in the United States on December 17, 2024
Functions as advertised.
Citizen Groove
Reviewed in Canada on November 24, 2024
Used these to raise the impedance of a friends multiple speaker setup to keep the amp from overheating and blowing output transistors. Worked perfectly.
Customer
Reviewed in Canada on November 18, 2024
Came broken
Ron, Florida
Reviewed in the United States on October 7, 2024
Within spec. Well built.
A.A.Rocks
Reviewed in the United States on October 28, 2024
Item As Described.
George Greenfield
Reviewed in the United States on October 19, 2024
I bought these to use as dummy loads for my old stereo repairs.both measure 10.5 ohms. At the high end of the trolerance level, howevert tehy are fine for my purpoes.Only issue is the markings on the resisteors is very had to see. I'm sure once heated up they will be illegible. Good product quickly arrived. Thanks.
Dr. Norman Weber
Reviewed in the United States on January 23, 2024
Well made and attached securely to the side of a radio chassis. It’s a safe way to prolong the life of vacuum tubes in many AA-5/6 radios.
Wayne
Reviewed in the United States on January 19, 2024
Built a Lipo discharger from two 100w 2.5 ohm and a aluminum heat sink. They perform well in discharging volt from the battery with very little heat exchange.
rural ontario
Reviewed in Canada on September 30, 2023
used to replace DRL resistor for headlightsworking well so far.just keep away from plastic or hoses when in use .
Recommended Products