Your cart is empty.
Your cart is empty.Raymarine ITC-5 Instrument Transducer Converter
Richard
Reviewed in the United States on April 25, 2024
If you do the math, using an ITC-5 with an Axiom or i70 is a better value than buying the i50s and i60. Plus fewer instruments to mount.
Kindle Customer
Reviewed in the United States on August 20, 2023
Perfect replacement for origional unit. Must be installed by qualified technician..
Customer
Reviewed in the United States on October 16, 2023
Simple to use, easy to install .... as near to plug and play that you can get
ColHam
Reviewed in the United States on September 13, 2022
Installed it with our new electronics. All Raymarine. It will not recognize the transducers. We know the transducers work because when we connect them directly to the instruments, they work. I keep reading about a firmware update. Cannot find any more information on how to actually do an update. Very frustrating.
Bart
Reviewed in the United States on January 28, 2022
Connected into the system and is working well
Brent
Reviewed in the United States on January 25, 2022
I really didn't want to go through the pain of replacing the through-hull depth sensor as I replaced all my electronics with a new Garmin-based setup, so I got this to interface to the existing sensor. Combined with a SeatalkNg-to-NMEA2K bridge, it works great, and was trivial to install. Sends the depth info to the Garmin chart plotter as intended!
Stephen R Carns
Reviewed in the United States on June 26, 2020
Good way to upgrade all of my old transducers into my SeatalkNG network without a haul out or replacing all the transducers with N2K versions. Easy install and came with everything in the box. Fast two-day delivery is a plus... something I have had in a while with COVID.
Ben Stein
Reviewed in the United States on December 20, 2018
I had a dead DataMarine DART system and was loathing the thought of having to replace my through-hull depth transducer to get a source of truth for depth of water under the boat. However, I also didn't have an NMEA 2000 bus on the boat at the time and knew I wanted one. Companies have sold devices for this application. Unfortunately Garmin doesn't make theirs anymore, but I took a chance that this RayMarine might work. It is designed to work with a 200kHz depth transducer. The DART's documentation says it uses a 205kHz transducer. Fortunately, this ITC-5 synched right up to it and is showing me reasonably accurate depth figures.It didn't do the same for water temp/speed but I have no idea if that sensor works on my boat, anyway, and I really don't care that much. I am looking forward to hooking up Raymarine's rudder position sensor shortly, so I'll have a source of truth for rudder angle.One star off, Raymarine, for inventing a way to make NMEA 2000 proprietary. Fortunately the unit will talk on an NMEA 2000 network with the appropriate adapter cable. I chose to make one with Maretron's field-installable connector, and to terminate my boat's back-bone on the bridge with a resistor on this ITC-5. Soon I'll be removing that resistor and extending the SeaTalkNG side of the network to install some RayMarine displays.
Recommended Products
$79.99
$ 37 .99 $37.99