Your cart is empty.
Your cart is empty.Product Description
In Wall IR Repeater Extender White Wall Plate Allows you to Easily Expand your IR system to other rooms.
Specifications
- Receive Frequency Range - 34 kHz to 60 kHz
- Transmit Frequencies - 38 kHz to 56 kHz Range - 40ft @ 38 kHz & 25ft @ 56 kHz
- Power requirements - 12VDC, 30mA max. This is powered from the Connecting block on our IR Repeater Extender System
- Wire Requirements - 2 twisted Pair, with our without shield
Additional Information- Infrared receivers pick up infrared signals within line-of-sight, and within 40 feet or so, and turn the signal into electrical impulses. These electrical impulses can be carried around the home on wires, and then turned back into infrared signals by emitters. IR receiver mounts in a wall electrical box to deliver IR commands to connecting block or distribution hub.
Our Dual Frequency IR wall plate receiver can be installed in any standard single gang box or P-ring.
This unit is a great add on to our advanced IR system and easily connects to the control block using standard cat 5e or cat 6 cables.
- Stylish deco design
- Color is White
- Dual Color LED for easy reference – Green for status and blue for confirmation
- Ultra thin design mounts easily in any J-box or P-ring
- Dual Frequency IR receiver
- Powered by the connecting block that is included with our Advanced IR repeater system
- Includes deco style faceplate
Easy Installation
- Strip back approximately ½” of the conductor on TWO of the pairs.
- Match the connection markings from the In Wall Infrared receiver wall plate to the connecting block of the advanced IR receiver.
- Installation Note - Most States require that when running cable inside walls, you must use fire rated cable such as CL-2 or CL-3.
- To avoid possible noise interference from induction from 115 VAC, never run low voltage and AC lines together.
- Room Placement: Place IR Wall Plate in direct “Line-of-Site” of the handheld remote control up to 35’ away and within a 120° of the device.
Front of IR Repeater Extender Wall Plate
- The Red Part is the IR Receiver window that picks up your remote control when you aim your remote at it and push a button.
- The small light below is a signal and confirmation light.
- You will have a steady green light when it is powered up and ready to go.
- It turns blue when it receives a signal from your remote control to show it received a signal and it sends it back to the IR Receiver
Rear of the 1140 IR Repeater Extender Wall Plate
Easy Installation using 2 twisted pair of wires from Cat 5e or Cat 6 cable.
- Connecting block +12V to V+ on the Wall Plate
- GND on Connecting block to G on the Wall Plate
- Status on Connecting Block to ST on Wall Plate
- Signal on Connecting block to IR on Wall Plate
Close up of the Connecting block from the IR repeater Extender
- If you want the Green status light and the blue confirmation light plug your AC adapter into the Status power outlet input.
- If you still want it to work but do not want to see the status light or confirmation plug your power into the power outlet input.
JA
Reviewed in the United States on October 30, 2019
Didnt work with Denon receiver but did with everything else
Recommended Products