Your cart is empty.
Your cart is empty.Product Description
BlastIR Wireless Pro
Control all of your home theater video sources (Blu-Ray player, Cable box, TiVo, and anything else that uses a standard IR remote control) from behind walls or closets by extending the IR signal with this kit.
Multi-Zone Control
The BlastIR Wireless Pro supports up to ten zones with independent sending/receiving frequencies. (Kind of like different channels on a walkie-talkie). You can change the zone by using a very small rotating switch located at the bottom of the receiver and emitter pucks. The Receivers will only communicate with the Emitters that are set to the same zone. You can also purchase extra Emitters, or Receivers individually if you do not need an extra full pair.
- Make sure that they receiver and emitter are set to the same desired channel before use. If they are on a different channel, then the emitter will not recognize the signal from the receiver.
All-to-All
The BlastIR Wireless Pro can be set to send the signal from all Receivers to all Emitters by setting all the units to the same "Channel" or "Zone".
Zone-To-Zone
The BlastIR Wireless Pro can be set to only send the signal from one Receiver to specific emitters.
Low-Profile
Each unit is no bigger than an average cookie.
Extend Reach with IR Emitter and Receiver Cable (Optional)
You can use the included Receiver and Emitter cables to further minimize what's seen on your setup. Magnetic Feet and Adhesive pads are also included to mount the BlastIR Wireless out of sight when using the IR Receiver and Emitter Cables.
Tech Guy
Reviewed in the United States on September 16, 2024
I have a LG OLED tv, Apple TV , and Yamaha surround sound Amplifier Receiver. This repeater worked briefly (5 minutes or so) but devices stopped responding shortly as though they were being overloaded with IR signal. The only reason I am guessing this was the problem is that the repeater was indicating it was getting IR commands, but everything stopped responding , even to the original remotes until I unplugged the IR repeater and removed it.
Michael Oppert
Reviewed in the United States on September 12, 2024
No dislikes. It does what I want it to do
Nicole Nash
Reviewed in the United States on December 22, 2024
When it worked it worked, it was good with only a short delay.
Rami Albert El Hagg
Reviewed in the United States on June 10, 2021
At very short range around 10ft the device has a huge lag up to 3 to 4 secondsUseless device
morbius2k10
Reviewed in the United States on January 4, 2021
Bought the tranmitter and receiver package, worked well. Had a second TV to watch from and bought the seperate transmitter (they dont sell the receiver seperately), only to learn the transmitter is what sends the r4emote signal to the gear you are controlling so I would then have one unit to point the remote at and 2 units to send that signal to the box to change channels...so backwards. I want to change the box channels from 2 locations, so I bought also the transmitter/receiver in one unit (expensive) and set it to the same channel as the others. When this unit is plugged in it works, but the other receiver does not until I unplug this one. This is supposed to work with 2 receivers on 2 TVs and one transmitter on one cable box. It does not do that, only one can control the units at one time. Terrible product.
Recommended Products