Your cart is empty.
Your cart is empty.Product Description
1
- ELRS 2.4G Receiver version diagram as shown left：
2
- The connection between the ELRS Nano receiver and the FC board is shown left:
3
- Enable the corresponding UART (e.g. UART3 left) as a Serial Rx on Betaflight Configurator "Ports" tab.
4
- On the "Configuration" tab, select "Serial-based receiver" on the "Receiver" panel, and select "CRSF" as the protocol. Telemetry is optional here and will reduce your stick update rate due to those transmit slots being used for telemetry.
Allan
Reviewed in the United States on May 16, 2024
Great little unit I would recommend getting a FTDI adapter to do the firmware updates or through the flight controller the wifi on it is a bit crap.And buy a few spare antennas.... they don't like propellers...(2.4ghz dipole ipex antennas)
Nick & Tiff
Reviewed in the United States on January 9, 2024
I just installed like 4 of these things. First time using and setting up elrs and it was pretty easy. Every one of these rx i've bought so far has worked perfectly except for my in ability to flash through usb. Wifi work fine though.
zonta
Reviewed in the United States on April 19, 2024
ExpressLRS is a fantastic RC control protocol, as many have noted. Because of its open development model, there is a ton of supported, low cost hardware. The developers have been happy to work with lots of manufacturers to ensure their products work well and can continue to be supported.This product appears not to be working with the ELRS team, however. Instructions say to use the BetaFPV software target, but the board does not have BetaFPV silk screening or appear to be an authorized rebranding or clone. While it does seem to function OK as it arrives, it's unknown how it will keep up with ongoing development while the manufacturer takes this approach. There are so many other choices that are taking steps to ensure quality and continued support and also sell at low prices, that there is no need to risk your models with this one while the situation is sketchy.
Matt
Reviewed in the United States on June 29, 2023
Works great! Love ELRS over all other protocols.
Julio Faudoa
Reviewed in the United States on December 7, 2023
I order one and it works great still using it .So then I ordered another one and at first it worked as expected for about 3 min then it gets really hot and loses connection if I power it off and let it cool down it works again till it gets hot I resolder it on another flight controller and it's the same thing????
Customer
Reviewed in the United States on January 16, 2023
The two best control links in my opinon are dji through the air unit and elrs. Elrs has a learning curve, but it is an adaptable link, it is worth the extra effort. Also it's open source so it's so much cheaper to buy. I haven't tried this rx yet but I am sure it works as it'd supposed to.
Frank M. Stein
Reviewed in the United States on August 3, 2022
No way to update with a binding phrase or updating firmware on receiver. There is no provided or available flashing target. Sologood is not listed in elrs config.I'll have to return it as it is unusable.
Deepesh
Reviewed in the United States on August 24, 2022
Works great! watch out for the RX and Tx pads on the module, It is flipped compared to other elrs pinouts online. Make sure you connect RX to TX on FC and vice versa for TX. Update using Beta FPV Nano 2400 for the module.
Recommended Products
$26.99
$ 11 .99 $11.99
$79.99
$ 33 .99 $33.99