Shopping Cart

Your cart is empty.

Your cart is empty.

Speedokote T-Rex White Bed Liner, 2K Urethane, SMR-1000W-K8 Truck Bedliner w/Free Spray Gun

Free shipping on orders over $29.99

$279.00

$ 99 .00 $99.00

In Stock
  • Easy to use: ADD hardener - SHAKE - SPRAY (see instructions below)
  • Abrasion and Stain Resistant
  • Protects against rust, corrosion salt, damp & extreme temperatures
  • Waterproof, flexible, helps deaden sound & vibrations
  • Provides excellent adhesion


This sale is for 8 plastic quart bottles of White Bed Liner (SMR-1000W) and 2 quarts of SMR-222 activator; which when mixed yields two gallon sprayable. Also included is a mixing cup for measuring activator and a free shutz spray gun to apply the bed liner. Note: If two gallons of sprayable bedliner is not enough for your job, then you may add SMR-1000W-K1 from Amazon. The SMR-1000W is a 1.7 lbs/gallon voc and is the only bed liner that is 50 state compliant. SMR-1000W is a true 2K urethane with outstanding adhesion to steel and sanded paint. This coating is formulated to withstand the same atmospheric conditions as a high quality single stage urethane topcoat. FEATURES: .True 2K Urethane Durability .Uniform White Color .Excellent Exterior Stability from UV Light .Fast Dry .Chemical Resistant Finish Easy to use: ADD hardener - SHAKE - SPRAY (see instructions below) SURFACE PREPARATION: Surface should be cleaned of all grease, oil, dirt, rust, etc before sanding. Wash area with soap and warm water, then rinse and dry. Thoroughly clean area with Wax and Grease Remover. Scuff surface with 180-220 grit sandpaper. Re-clean with wax and grease remover, then dry with a clean towel. Instructions: Apply Bed Liner between 60 - 85 degrees F and humidity less than 70%, Not in direct sunlight. 1. Add 8 ounces of SMR-222 activator to a quart bottle of SMR-1000. 2. Screw on quart bottle cap and shake for two minutes. 3. Remove the cap and screw in the Shutz Spray Gun. 4. Adjusting the air pressure (60-80 PSI) and spray distance will change the texture. 5. Apply a uniform wet coat of bed liner using a sweeping motion. 6. After a 2 minute flash, apply a very light 2nd coat, sprayed at 80 PSI, using a fast sweeping motion.


Royal
Reviewed in the United States on May 9, 2023
I was a little nervous about purchasing this for the roof repair on our pop up camper, but it worked flawlessly! It came with good instructions and the sprayer was very easy to use. Great product I would highly recommend. I’ll be ordering more for the bed of my truck 👍
Carolyn M
Reviewed in the United States on March 19, 2023
My Coleman pop up roof was covered in hairline cracks. I covered the cracks that appeared to be loose with gel gloss tub and tile repair and then used a 3/8 “ nap Purdy white dove roller for the Speedokote. The results are awesome. It took me less than 2 hours. No more cracks and nice new smooth textured finish. You would never know that it is 22 years old. It is a 10 foot camper and I used 6 qts for a good cover.
Customer
Reviewed in the United States on October 16, 2023
Used this product to redo our pop up camper shell! Was a little hesitant to pull the trigger but this worked great! Easy to mix and apply and saved us hundreds vs having it done professionally.
Scott S
Reviewed in the United States on August 20, 2021
I sprayed the roof of my pop up camper.I chose this product over others after evaluating the cost vs the expected life of the trailer...it worked great, sprayed well and was easy to use. It did go on a little thin so it took more product than expected but the finished product was great.
L. Hua Po
Reviewed in the United States on September 22, 2019
I sprayed the entire outside of my truck with this stuff. It was very easy. My wife did the mixing and shaking up (2 minutes of shaking required) one bottle at a time while I was spraying, then we swapped bottles and I kept on spraying. We were done in less than an hour and the truck looks great. This is one of the white-paint-peeling trucks from 2001 so the white bedliner coating is perfect. I'm no painter and I got it on just fine. Another nice thing you can see in the picture, it didn't coat the ground or even my old boots---I did wear disposable coveralls though.
Allan Lazarus
Reviewed in the United States on September 16, 2018
I used this product to renovate my tent trailer roof. The original ABS roof had cracked over time and use of the Speedokote bed liner as alternate cover is in wide use. The stuff works great. Application is easier than you think. Watch YouTube for how-to. But it is toxic. You have to wear protection and once it’s on it’s on. Trailer looks great. But I bought a second case as advised by others. One case was enough for a 12 foot long roof. Speedokote would not allow return of second case as I had it over 30 days. Anyone need a case for cheaper than Amazon?
Ringo
Reviewed in the United States on July 31, 2017
We have 14' popup camper in the family that was written off by insurance after hail damage. After reading a few posts on the internet, we took a chance on spraying this bedliner on the roof of the popup. Results are spectacular! Looks brand new, like it was meant to be. And no leaks all summer long.Note, we used all 8 bottles on this large popup roof and nearly ran out! For normal size popups in the 10-12 foot range, buy the 8 bottle kit and dont skimp!
Larry
Reviewed in the United States on May 31, 2016
Love this stuff this is the fourth batch for me. Easy to install this product. I have done two truck beds before flipping vehicles, am now doing a flatbed truck for flipping, Awesome stuff and looks very professional, I ordered white because I goofed on my ordering, but ended up keeping it for other projects, looks like a nice color white. Would surely recommend to people and have done so. I might even do a couple jobs for monies.