Your cart is empty.
Your cart is empty.Freak
Reviewed in the United States on July 16, 2024
Worked flawlessly. I jammed it in hose, snuck other hose on other end. Clamped and No Crap It Worked....
Larry D Barnes
Reviewed in the United States on December 2, 2024
works good
Ant
Reviewed in the United States on January 12, 2024
Great for using my existing intake boot on my 98 ram.
RFlowers
Reviewed in the United States on March 25, 2023
Nice looking polished aluminum coupler. Fit my custom application. Too bad nobody can see it because it's covered by hoses.
Dewey
Reviewed in the United States on November 9, 2023
I swapped a 4.0 jeep head and EFI onto a 258 block in a CJ-5, Speeduino setup. 16ga is nice and strong. This 3.25" hose adapter worked great for mating a cheap cone filter to the stock Jeep 4.0 throttle body rubber intake hose. I'm now going to weld an aluminum 1/4" NPT bung on it to relocate the IAT sensor (it gets too heat soaked in the manifold).
YOUTUBE'S 'REDNECK CHANNEL'
Reviewed in the United States on September 14, 2022
AAAAA FITMENT AND FUNCTION
Gas Man
Reviewed in the United States on March 22, 2022
Used this to connect cone air filter to factory intake tube on Honda Civic. Not much more to say other than it’s a shiny aluminum tube with a bead rolled on each end to keep the rubber hose from popping off when secured with a hose clamp. Got it quickly, too.
96_teck
Reviewed in the United States on October 3, 2022
Used it to mate a 4.5 inch filter to a 4.5 inch silicone intake.
Recommended Products
