Your cart is empty.
Your cart is empty.SeekLiny V5 J-Head i3 Mega Hotend 12V 40W with 2pcs Hardened Steel 0.4mm V6 Nozzles for Anycubic i3 Mega S X Series 3D Printer Extruder Hotend
Chris g.
Reviewed in Canada on September 2, 2024
Got it and did not work something wrong with the heating barrel it has a short
Curtis Cox
Reviewed in the United States on March 19, 2024
Displays selected temperatures but heats to nowhere near the temperature displayed. Pure trash.
Meni
Reviewed in the United States on October 21, 2024
Works perfect for my i3 Mega. .4 nozzle gives a good quality and print surface. It was easy to install just watch a YouTube video! The wires were a bit long but still fit up easy. With the two extra hardened nozzles and the brass the value is great!
Gregory Chesser
Reviewed in the United States on June 2, 2023
This is correct print head with the correct wiring, white wire ends...I had a problem with others selling the correct print head, but the wrong sensor and heaters with the black cable ends...
what's up doc?
Reviewed in the United States on March 21, 2023
While it looks like and acts like an E3D clone, there is a huge difference is size. If you don’t factor that in, you will need to reconfigure you printer entirely. Had to order a real E3D clone to replace my original broken one. This one was too big.
J. Sean
Reviewed in the United States on February 16, 2023
Works wonderfully. Good length to harness wires as well. Facilitated easy installation even on diy printer
Saul
Reviewed in Mexico on January 1, 2023
El producto es como se ve en la imagen, y cuenta con todo lo necesario para poder realizar impresiones 3d
Amanda Yeatts
Reviewed in the United States on August 27, 2022
Atttttt
M. Banks
Reviewed in the United States on June 15, 2022
Would not recommend, first one I got started causing my printer to throw T0 sensor errors after install and failed several prints. While Amazon replaced it without issue, it took my time to replace the hotend 2x (assuming the replacement is better) and work to process the return/replacement. Better to spend a bit more and only have to deal with it once.
Eli
Reviewed in the United States on December 29, 2022
It was a super simple install, I do find these smaller nozzles clog a lot easier for some reason which can be a pain to remove/replace. But they are required as far as I can tell on the mega S.
Gerardo M.
Reviewed in Mexico on December 21, 2022
ESTA ENTREGA DE IGUAL MANERA EN TIEMPO Y FORMA ME GUSTO POR LAS BOQUILLAS QUE ME DAN MAS DURACIÓN EN MIS IMPRESIONES.
Recommended Products
