Your cart is empty.
Your cart is empty.DINGUS ¼” feed-thru adds easy-access audio cable connectivity to a Voodoo Lab Dingbat pedalboard. This handy add-on works for both mono and stereo connections and installs beneath either side of a Dingbat pedalboard. From simple guitar and amp connections to more complex stereo and effects loop setups, DINGUS makes cable routing clean and convenient.
Ski Bear
Reviewed in the United States on February 9, 2025
These are easy to install on the Voodoo Lab Dingbat pedalboards and a must have for those boards! I have no noise of other connectivity issues at all with these 1/4 TS & TRS throughs for guitar cables.
AZ Customer
Reviewed in Canada on February 26, 2025
I hate disconnecting my pedal as it (can) wear the jacks, and on higher-end gear, I don't want to replace them. This fits perfectly on the underside of my board and does precisely want I need it to do.
Gerardo
Reviewed in the United States on July 27, 2024
Compré este producto y me a funcionado exelente
Another Pilgrim
Reviewed in Canada on May 18, 2024
I needed to make a remote outlet for my instruments, and this device is a perfect solution. Built quality is excellent - solid metal. It also comes with two tiny screws, I assumed, to attached it to a pedal board. I connected it to my sound module instrument inputs using TR instrument cables. Now I have two external inputs exactly where I needed them with no messy cables on the floor: no noise, no hum, perfect cable management solution.
guillermo muñoz
Reviewed in the United States on July 19, 2023
MUY BUEN SERVICIO DE ENTREGA Y MUY BUEN PRODUCTO
jham
Reviewed in the United States on May 22, 2023
This product is well built and serves the need to have a permanent in/out box for your pedalboard
jim cochran
Reviewed in Canada on December 14, 2023
It would have been nice if they had 4 inputs instead of 2
Michigan Family
Reviewed in the United States on March 5, 2022
So you look at this and go why? Its a female to female connection. But it allows you to dictate a consistent point for your guitar input and send to front of amp. If you use an effects loop you can do same for this as well. In this manner, you always plug into same spot and then you can make a custom cable to route from Dingus to the first pedal in the chain and back from the last, no matter where you put it on the board. Just a nice touch. I think top end boards should have this built in to the pedal base as standard.
Lance C.
Reviewed in the United States on July 19, 2021
This junction box does exactly what it is supposed to do, it did not add any noise to my pedalboard, it is built very solid, but for what it is, i would say it cost more then it should, but it works well and really cleans up the inputs and outputs of your pedalboard, I bought two, one for each of my two pedalboards.
Vincent Z.
Reviewed in the United States on March 20, 2021
Must have addition to my pedalboard. Save your pedal inputs and outputs!
César D León
Reviewed in Mexico on February 2, 2021
Cuando llegó provocó un ruido de tierra terrible. Tuve que modificarlo para que funcionara
Bobby Lombardi
Reviewed in the United States on April 19, 2021
A relatively simple box, 2 x 1/4" passive pass-throughs for Voodoo Lab Pedalboards. The box is really sturdy and well made and attaches with two pre-threaded screws to the Voodoo Labs pedalboard. I have installed two of these Dinguses to my pedalboard for guitar input, amp output, and 2 expression pedal inputs. A little expensive but well worth the money considering this is a small local company in California and extremely well built.
Recommended Products
$49.90
$ 25 .99 $25.99