Your cart is empty.
Your cart is empty.Westin(TM) E-Series Nerf Bars are made of 3in. diameter round tubing and are vehicle specific designs. Step design and mounting technique varies by application (mounting kit included). They feature recessed area mounted step pads unique to E-Series Nerf Bars feature the Westin(TM) brand name and are UV resistant.
VokeyWedgeFan
Reviewed in the United States on April 8, 2014
I purchased these for my 2012 Colorado LT Crew Cab. The installation was pretty straightforward with the only caveat being that the rear mounts for the driver and passenger sides had to be swapped (I read on another post where they were labeled incorrectly and that proved to be the case for my installation as well). Once I figured out that I had to swap the rear mounts, the passenger side rail went on without a hitch -- no rattles, squeaks, etc.However, the same cannot be said for the driver's side rail. It seems that the middle mounting bracket butts right up against a piece of the frame, and I have been battling a squeak/rattle for about two weeks post-installation. That is the only reason that I gave it four stars instead of five -- I'm not 100% sure that the design allows for enough clearance for this middle mount, although the instructions state that the front and middle mounts are interchangeable.Would I buy these again? Absolutely. For the price you cannot beat the look, especially on a black truck. However, I'm probably going to have to find a buddy with a vehicle lift to resolve my squeak/rattle on the driver's side.
CycoStu
Reviewed in the United States on February 16, 2012
This is a great sturdy step bar set. Good powder coating and fairly easy to install. The only issue I ran into was the front main mounts were miss marked. The passenger side was for driver and vice versa, but other than that simple. I would recommend laying out all the bolts and washers as it made it far easier to determine what went with what. Westin did a great job of having the brackets in separate colored bags. One side was in clear bags and the other in green, also all the parts had letter designations like "DF" for "Driver's Front" which was helpful, except for the one mix up that was easy to figure out.Also it should be noted that the factory body mount bolts on my 2004 Colorado were serrated and would not just slide off the rubber washer bushing. I had to gently use a Dremel so as to lower the high points enough to get the bolt out to be able to install the brackets properly. The instructions made no note of this possibility so not sure if it was done on all years this bar will fit or just the early years. Remember to use caution as this is a critical bolt for both the step bar and the body of the truck. I still had to tap mine through the washer so it was still snug fitting.
Recommended Products
