Your cart is empty.
Your cart is empty.
Specification：
Voltage Supply: 9-12V DC Input
Waveforms: Square, Sine & Triangle
Impedance: 600 Ohm + 10%
Frequency: 1Hz-1MHz
SINE WAVE
Amplitude: 0-3V at 9V DC Input
Distortion: Less than 1% (at 1KHz)
Flatness: +0.05dB 1Hz - 100kHz
SQUARE WAVE
Amplitude: 8V (no load) at 9V DC Input
Rise Time: Less than 50ns (at 1KHz)
Fall Time: Less than 30ns (at 1KHz)
Symmetry: Less than 5% (at 1KHz)
TRIANGLE WAVE
Amplitude: 0-3V at 9V DC Input
Linearity: Less than 1% (up to 100KHz) 10mA
Package included:
1 x XR2206 Function Signal Generator DIY Kit (Not Assembled)
1 x Instruction
Package Size: 12 x 8 x 2cm / 4.72 x 3.15 x 0.8in
Note: This Kit need to be assembled by yourself. Straight inserted components, simple installation.
tracie keys
Reviewed in the United States on February 22, 2024
Missing one of the 5.1k ohm resistorsAnd received in the parts but defective when tested with multiple testers the ceramic non polarized capacitor 101Is there any possible way to communicate with seller and see if I can get just these replaced / sent to me?
Kenneth M.
Reviewed in the United States on February 17, 2024
The material of the jumpers is so soft I did t even get to use it one time. I tried everything but they’re to thin to work with. Also can’t read the faded instructions! I smashed it with a hammer and threw it in the garbage! I know it was cheap but c’mon!!!
RH
Reviewed in the United States on December 11, 2022
The Treedix XR2206 Signal Generator for under $10 is a great value and actually works. All electronic and hardware parts were included. Perhaps the most difficult part about assembly is removing the protective film from the case parts. A couple of tips may help. First, the circuit board is attached to the case bottom with four short screws and nuts. For enough of the screws to protrude so the nuts can be attached, all of the component leads have to be shortened to nearly flush with the back of the board. Second, the holes for the longer screws that hold the case together are actually laser cut through the plastic in a star shape in the case bottom. You will need to carefully push out the center of the cut out. It is a good idea to support the case bottom when doing this. When the case is assembled, the longer machine screws will actually thread themselves into the plastic star shaped hole. Be very careful not to over tighten or you will strip out these tiny threads. The video on assembly is helpful.
Ray Purchase
Reviewed in the United States on May 2, 2021
Kit is missing multiple parts.I've already soldered a couple parts and don't want to go to the hassle of a return.Just a bit of a let down.
Recommended Products
