Your cart is empty.
Your cart is empty.K1 Nozzle Kits K1c Nozzles Ender 3 V3 KE Quick Swap Hardened Steel Nozzles High-Speed Printing and High Flow Extruder Nozzles
D. Porrey
Reviewed in the United States on September 16, 2024
I upgraded my Ender 3 V3 Ke to use this hot end. I have had some issues with clogging but overall this works well. Heats up quickly and it is easy to exchange the nozzle. All parts necessary are included.
Software Poet
Reviewed in the United States on September 14, 2024
This is a good aftermarket nozzle kit for the Creality K1. It comes with the screws and stand-offs needed to properly align the nozzle kit to the heat sink.The cost of this kit runs about 30% less than the OEM kit. From my early printing, it seems like the results are as good as the OEM kit.The silicone sock on the kit doesn't feel as snug as the OEM, that's the only thing I can see right away that made the whole thing feel slightly lower quality, but that's such a minor detail, it probably will be great over the life of the kit.
Mark Messmore
Reviewed in the United States on August 22, 2024
I have an Ender 3 V3 KE, and recently my nozzle got all gummed up. I pulled out this batch and popped one in without issue. So far everything is working well. Admittedly, I have only used 0.4 nozzles and have not ventured out to 0.6 or 0.8. However, that is a general statement and has nothing to do with this product in particular.
Denis P.
Reviewed in the United States on August 14, 2024
the can was hard to get the lid off but not to worry after the lide is off you need tools to get the nozels out of the hard to deep foam
Ham Radio Guy
Reviewed in the United States on November 3, 2024
It's a heating head it works okay I wish Amazon would just let you leave stars and go down the road. I haven't used the thing yet and I'm hoping the creality makes a good product. Honestly I'm hoping it stays in the spares box and I don't need it.
David L.
Reviewed in the United States on October 21, 2024
These fit exactly like the OEM. The entire kit is cheaper than buying two of the original nozzles. I have had no issues using the .4 so far.
Dave W.
Reviewed in the United States on October 18, 2024
The installation of these nozzles has resulted in a noticeable enhancement in the quality of my prints. The prints exhibit a significantly higher level of detail and precision. Additionally, I have observed a substantial increase in the durability of the prints. Since the installation of these nozzles, I have not encountered a single instance of clogging, which has resulted in a significant reduction in the time and frustration associated with print failures.The ability to replace the entire hotend interior as a single unit, without the need to remove the heater, offers a significant reduction in the time and effort required for maintenance.While the initial cost of the product may appear to be cost-effective, it is important to note that the full cost-effectiveness is only realized when the assembly is replaced with an upgraded hotend, such as the unicorn assembly, to ensure proper fit of the heatstop. The original heatstop was not compatible with the heater, necessitating the initial replacement of the assembly.The printer demonstrates a marked improvement in its functionality with the installation of this unicorn hotend.
Recommended Products
