Your cart is empty.
Your cart is empty. Features and functions
The 12V flasher relay is compatible with most 2-pin flasher relays and works for most brands of motorcycles. When your light bulb doesn't blink or blink too fast. You need to change to this flasher relay. It can keep and control the led bulb flash at a normal rate, which improves your riding experience.
Specifications
Operating Voltage: 12V (11V-15V)
Max Power: 150W
Flashing Frequency: 90 Times/Min
Switch Power: 0.02A to 20A
Operating Temperature: -40°C to +80°C
Material: ABS Plastic, Copper wire
Wide range compatibility: Compatible with replacing the most 2-pin flasher relay. if the wiring connectors are different, you can remove the white connector to plug in the wires or new connectors directly.
Compatible Brands
Honda: CBR600 CB900 CBR1000 VTX1300 VT1300
Suzuki GSX R600 R750 R1100 GSF600S GSF1200S
YZF FZ WR
Kawasaki Ninja ZZR ZX VULCAN, etc
Ideal replacements
This part is the perfect replacement for your motorcycle. They have been tested by the manufacturer to make sure that they work perfectly and impact your led bulb positively. You can replace the flasher relay yourself easily and quickly without any problems installing it.
Search no further!! Click Add to Cart to get this 2-Pin 12V Electronic LED Flasher Relay
MATTY B
Reviewed in the United States on September 8, 2024
I need instructions immediately on how to install or a diagram. At least you should totally be held accountable for not having what you need delivered to you in the package.
Diane Adams
Reviewed in the United States on September 7, 2024
Automotive wiring job
Kindle Customer
Reviewed in the United States on December 31, 2024
Lucky they come in fours, only needed 2 for now and only 2 worked properly.One did not flash at all, always on and the other only dimed slightly from full brightness, instead of turning on and off. 50% is not good enough for me, so I can't recommend this product.
Michael Bortman
Reviewed in the United States on March 18, 2023
Works perfectly. Installed on my Bonnie to cure the hyper flash after installing LED turn signal bulbs. Plugged right into the factory harness although the locking tab is long. Used a small tie wrap to secure. Trimmed a little plastic off the holding tab and it fits into the factory rubber mount. Price is fantastic for four of these, now I can share the extras with other riders.
Brandon Reed
Reviewed in the United States on October 3, 2023
Works great!
MB
Reviewed in the United States on June 1, 2022
I installed this on my 1996 dr650. If you plan to install LED lights on this year, make and model I would recommend adding this to your list to get. Easy to install and worth the money.
nathan
Reviewed in the United States on May 28, 2022
connected flawlessly to the factory harness of the bike. 2017 vulcan S 650. Cheaper option than some of the other "high-end" ones out there.
Robert
Reviewed in the United States on December 13, 2022
I didn’t need them for the turn signal project I was doing. Turns out the signal themselves had built in flashers.
Recommended Products
