Your cart is empty.
Your cart is empty. Specification:
Product Name: Tee Fitting
Model: PE-4
Size: 37mm x 24mm x 11mm/ 1.45” x 0.94” x 0.43” (L*W*H）
Operating Pressure: 0-0.9MPa
Limiting Pressure: 1.32MPa
Operating Temperature: 0-60 Degree Celsius
Three Tube Size (OD): 4mm(5/32”)
Color: Black, Blue
Material: Plastic
Installation:
1. Cut the pipe flat without slope.
2. When inserting the pipe into the connector, it must be inserted into the end, otherwise leakage may occur.
3. After inserting, try to pull out the tube. If it can't be pulled out, it means it is connected.
4. When loosening the tube, first confirm that the tube is not under pressure and then press the end cap evenly to the bottom.
Note:
Due to different shooting methods, the actual appearance of the items will be slightly different which will not affect the overall use.
Package Content:
40 x Tee Fittings
The Gregory Family
Reviewed in the United States on September 3, 2024
It’s hard to install the tubes properly and they leaked more often than not. I returned it.
Drew
Reviewed in Canada on March 18, 2024
The interior ports of the fittings are extremely restricting, nowhere close to 1/2" cross section of your tubing. Do not buy if you need proper flow.
Nny
Reviewed in the United States on August 7, 2023
These are pretty expensive and won't fit most 1/4" PTC connectors or hard lines. If they do fit they will likely never come off. Extremely tight fitting
Cliff P
Reviewed in the United States on August 10, 2022
These came fast worked well and were priced fairly
Deborah C.
Reviewed in the United States on June 14, 2022
Great for adjusting in tight places
ken m.
Reviewed in the United States on May 5, 2022
These were slightly too small to properly fit 1/4” air line. All were too tight and did not provide an airtight seal. They must not be SAE size, they must be metric and wrongly described.
Shane Richard
Reviewed in the United States on December 6, 2022
I used this to cut a airline to add a retractable airline kit for hooking up to disabled vehicles off my wrecker.
Pilot68
Reviewed in the United States on December 16, 2020
I bought these for a plumbing project because nowhere in the listing did it state "FOR AIR USE ONLY". I was able to make them work, but time will tell if they start to develop leaks or not. They should have made that point abundantly clear in the description.
Michael Honcho
Reviewed in the United States on October 24, 2020
THESE WILL NOT FIT 1/2"!!!!! STOP ASSUMING MM ARE EQUIVALENT TO SAE.
Recommended Products
