Your cart is empty.
Your cart is empty.Product Description
Product Description
Note: This kit need the external power adapter to power on the device.
Passive PoE Injector and PoE Splitter Kit allows low cost of delivering power over the network cable for shorter distances.
This kit allows power to be carried on 10/100 networks over the spare, unused pairs of a CAT5, CAT5E, CAT6 or CAT7 Ethernet network cable.
On shorter network lengths, The power source could feed the wireless access point, IP video surveillance camera,Ip phone etc.
Package Include:
5 Pairs POE Splitter Cable
(5pcs with DC Male plug and 5pcs with DC Female Plug)
This Kit contains both very cost effective injector and splitter.
The injector inserts the DC voltage at the source location into the 5.5mm x 2.1mm injector plug
Then the DC voltage run through the spare pairs of the 10BASE-T or 100BASE-T network cable to the Splitter side,
And the splitter splits the DC voltage from the network cable into the 5.5mm x 2.1mm DC jack. Power feed Pins: 4/5(+), 7/8(-)
Claude Marchand
Reviewed in Canada on January 26, 2025
Fonction bien
Joshua
Reviewed in the United States on January 11, 2024
These work well, but the listing never mentions that you will only get 10/100Mbs with these. They only use 2 of the pairs for the data, and put the power on the other 2 pairs of the ethernet cable.It''s nice that the power plug works perfectly for TP-Link Deco X55 Mesh wifi modules.
P.M. Ariza
Reviewed in the United States on June 6, 2023
Great value pack and excellent quality and performance.Need to power an Access Point, Camera, etc but no AC outlets are nearby ? this is the product you need. We had a unique situation where we had three (3) access points to install in locations where no AC power outlets were installed. This would not be a problem if the Access Points could be powered by POE but these units could only be powered by a 12VDC power adapter. These adapters allowed us to centrally power the APs while sending data and power over the same cable. All is well that ends well.
Hugh C.
Reviewed in the United States on February 25, 2023
Needed to extend my cameras 30 feet. I used ethernet wire and was able to run long and inexpensive length for my cameras.
Scott
Reviewed in the United States on September 5, 2022
Great way to make non POE into POE
Mike and Annilie Michalko
Reviewed in the United States on May 11, 2022
This was the best solution to POE switch.
Jpsoulmate
Reviewed in the United States on August 25, 2021
Quick shipping and great price
Jason Thames
Reviewed in the United States on May 6, 2021
I use it to make my old Comcast cameras work.
Squatch
Reviewed in the United States on July 30, 2019
product is amazing when combined with shorter PoE cables, but it simply does not have the ability to carry such a current through 100 ft.update: you can definitely still use it, just make sure you use a good power supply. I needed 12 volts at 2 amps for 8 cams; about 24 watts a piece. I bought a 360 watt 12 volt 30 amp power supply and simply connected 2.1x5.5 lines to it. these adaptors work fine, even with the extra juice ( needed due to 100ft being too great)
Recommended Products