Shopping Cart

Your cart is empty.

Your cart is empty.

AlveyTech 3/4'-16 Lock Nut for 1' Go-Kart Axles

4.8 (4) Write Review
Free shipping on orders over $29.99

$8.09

$ 3 .99 $3.99

In Stock

About this item

  • 3/4"-16 Lock Nut for 1" Go-Kart Axles.
  • The 3/4"-16 is common on 1" axle that have the 3/4" step-down on either end.
  • This 3/4"-16 lock nut for go-kart axles threads onto the axle shaft ends to hold the wheel in place.
  • Used on many go-karts and dune buggies of various sizes.


A small piece of hardware perhaps, but one that is vital to your go-kart's drive system. This AlveyTech 3/4"-16 lock nut for go-kart axles threads onto the axle shaft ends to hold the wheel in place. The 3/4"-16 is common on 1" axle that have the 3/4" step-down on either end.


Ed Wilson
Reviewed in the United States on March 17, 2025
These are heavy duty. Nuts with nylon inserts for locking nut in place. They should not used more then twice ,because the nylon looses it's locking ability . The threads cut into nylon
CCC Corvettes
Reviewed in the United States on September 10, 2023
just what was needed
Johnny B
Reviewed in the United States on May 21, 2022
Great item 👍🏼
David & Abigail Kligmann
Reviewed in the United States on March 28, 2021
These hold tight to a fault. The nylon makes it a little too difficult to install or remove. If you're looking for an absolute lock, these are really good for that, I just like something a little easier install or remove.