Your cart is empty.
Your cart is empty.Product Description
Ben
Reviewed in the United States on September 3, 2024
Hose kit comes with everything you need to connect the discharge of your bilge pump (pump not included).
Jasonm
Reviewed in the United States on May 7, 2024
This is a good complete kit to connect to your bilge. There is a good length of hose to route to where you need but also easy to cut. The hose is thick enough to not kink but still flexible. I didn’t use the outlet port but it’s there if you need it. Works well and doesn’t leak.
Billy B
Reviewed in the United States on May 17, 2024
I needed a little more hose to reach the sink in my boat. I won't use the included hull fitting since the sink drains to the outside. This hose if very flexible allowing tight turns for small spaces. I was easily able to route the hose from the bilge through the inner wall to the sink. The hose was the correct size for my bilge pump and attached securely without leaking.
Tom
Reviewed in the United States on May 12, 2024
This is not your typical plastic bilge hose that is light weight but kinks. This is heavy duty gnarly hose. Very similar to what you would get on an old Electrolux vacuum. It is reinforced with ribs. It is a bit on the heavy side. It comes with the hose clamps and a hull pass-through pipe.It is not cheap, but it is high quality. If you are looking for something you trust in the bottom of your hull, this should do the trick. I am going to use this for a portable bilge which is a bit overkill but should last me forever.
Steveoh
Reviewed in the United States on November 3, 2024
Holy heavy duty bilge pump hose. Compared to the typical bilge pump hose, this is heavier, thicker, less flexible, BUT I suspect a lot more resistant to UV light. The old hose crumbled in my hands.I go way off shore in my Tolman Skiff and the thought of my bilge pump hose failing in rough seas makes me itchy. So heavy hose is a preference. Didn’t need the through hill as I already have one. Would appreciate buying the hose separately to save a buck.Five stars if there were built in flats for the hose clamps.
Explorer777
Reviewed in the United States on October 8, 2024
Old hose was cracked and dry rotted. Very happy with this house. Heavy duty, and smooth on the inside for proper flow.
Remington Rodriguez
Reviewed in the United States on October 29, 2024
Everything was as described. No isssues. InstalledEasily functions perfectly
Brian Giller
Reviewed in the United States on April 26, 2024
This hose is very well made and heavy duty. The outlet piece and clamps are also high quality. The only issue I see is that the hose inner diameter is oversized enough that on a non-flanged fitting it may be difficult to clamp it down tight enough to get a good seal. Usually a hose like this has to be pressed on with some force and then you clamp it. This hose slides on and off with no resistance so there is a moderate gap. Pressure will be low enough however that it may not be an issue.
Recommended Products