Your cart is empty.
Your cart is empty.Product Description
Bob
Reviewed in the United States on March 6, 2025
Fits 3/4” slot
Mark R
Reviewed in the United States on March 13, 2025
These fit perfectly in my guides. There is "no" play from side to side and they slide the length with "no" sticking anywhere. I am very pleased.
Michael J.
Reviewed in the United States on March 10, 2025
These slides fit the miter slots on my Grizzly table saw perfectly.
ActualCustomer
Reviewed in the United States on February 5, 2025
Perfect fit for my miter slots. Supplied screws are apparently stainless steel and of much better quality than I expected. I don’t write a lot of reviews, but this is a good product at a reasonable price.
John Schwartz
Reviewed in the United States on January 2, 2025
I like that these were prefab jig slides with countersunk screws provided. They were supposed to fit into the T-track without a fuss. However, I needed to spend a considerable amount of time sanding and fitting these slides to get them to fit into the T-track channels on my table saw and fitting onto the crosscut sled that I was making.
sulmax99
Reviewed in the United States on January 10, 2025
The only improvement I would suggest, for the manufacturer, would be to finish the sides to a smooth, flat finish, rather than leaving rough saw marks. I had to sand both rails before I could use them.
Sue
Reviewed in the United Kingdom on August 2, 2024
Great value and will recommend to friends and family thanks
robert brain
Reviewed in the United Kingdom on March 30, 2024
cross cut sled thanks robert
Charles Davis
Reviewed in the United States on October 4, 2024
Three of the units fit my saws miter slots very nicely. The 4th unit didn’t even come close. Suggest better quality control.
Chris Nicholson
Reviewed in Canada on October 28, 2024
Item delivered on time and exactly as described.
Kindle Customer
Reviewed in the United States on July 27, 2023
Just what I wanted for my crosscut sled, but they need to be slightly resized to fit the 3.4" miter grooves in my table saw.
John Dunn
Reviewed in Canada on December 30, 2023
I am very impressed with the quality, all ready for install but with winter arriving my shop is cold so will not be installing these until the spring when metal is at a better temp . might even plan on a few other sled designs and order a few sets as I am rebuilding an old 1970 unit then as well,
Customer
Reviewed in the United Kingdom on October 26, 2023
Purchased 4-pack of plastic runners for table-saw sled. 2 perfectly straight, 1 slightly bent out of true, albeit not so much as to be unusable, but 1 so distorted as to be effectively useless (see photo).Have immediately done a Buy Again on a further 4-pack in the hope at least 3 of them will be useable, but will definitely be requesting Amazon to issue a refund equivalent to the price of a 2-pack, on the grounds of defective product.
Recommended Products