Shopping Cart

Your cart is empty.

Your cart is empty.

DigiAutoPart Throttle Position Sensor (TPS) Connector wiring harnesses 1U2Z14S411AFA

Free shipping on orders over $29.99

$13.00

$ 5 .99 $5.99

In Stock

About this item

  • Wire Harness Length:10CM
  • Direct replacement for easy installation
  • Constructed from high-quality plastic for greater durability
  • Premium copper-, nickel-, or silver-plated electrical terminals to ensure robust electrical connectivity


Popular Fitments


leslee
Reviewed in the United States on January 17, 2025
Made well.
T. W.
Reviewed in the United States on August 11, 2024
Fit like original but for less than half the cost of OEM part.
Aaron Yoder
Reviewed in the United States on July 13, 2024
All good
GadgetDan
Reviewed in the United States on March 29, 2024
My symptom was occasionally having no accelerator at all when I press it. This part looks identical externally, but did not fit. My throttle has a flat spline connection, like a flat screwdriver. In this picture the OEM Ford is on the left, this part is on the right, with the two tabs protruding into the middle hole. This spline connection is exactly opposite of what I need. This pedal sensor was VERY easy to access on my 1999 Super Duty, it is on the left side of the accelerator pedal assembly with nothing in the way, 5 minute job. It is secured with two T-25 screws and a push-button plug connector. Check yours before ordering, Ford must have used two different types of splines, possibly changed in later years after April 1998, when mine was built. The sunshine is spring loaded, so it will automatically be at the correct position when installed. You may need to press the pedal a bit and wiggle the sensor to get the it to drop back into position. I exercised mine back and forth a few dozen times and stuck it back in, it should be fine until a new one shows up.
Jack Johnson
Reviewed in the United States on April 8, 2024
It looks right, and starts to go on, but the terminal slots are too small and do not fit.
ROMO
Reviewed in the United States on August 13, 2023
Many times electrical repair kit or electrical repair pigtails are not available from the vehicle manufacturers. Many times the word that you hear from their parts department at the dealerships is: "have to replace the whole harness" or "engine harness is no longer supplied" hence no longer available.As the plastic housings are aging (especially with the heat under the hood) or they break when trying to disconnect them, it is such a great thing to find replacement electrical pigtails.For this one, I removed the wires with the pins from the pigtail and replaced the plastic housing only, as the latching tab on the OEM connector was broken and the connector was loose and the pins were not always able to make a good & stable contact.I do have a couple more connectors to repair with pigtails from the same manufacturer or from the Standard Motor Products. Go to their website to find the electric repair pigtails by looking for the sensors that they attach to.
Aaron1989
Reviewed in the United States on March 5, 2023
2002 ford f150 5.4
Unique
Reviewed in the United States on December 10, 2023
Dispite making sure it was compatible with my vehicle it did not fit. It looks like not should fit but for some reason it can not fully engage. Either poor quality or I feel like Amazon must have a poor system to check if the vehicle parts are compatible or not. I'm disappointed and to make matters worse I can't return it.
David Zamora
Reviewed in Mexico on November 1, 2022
Se ajustó perfecto a mí Ranger 2000. Sin defectos ni fallas en la pieza.
Recommended Products