Shopping Cart

Your cart is empty.

Your cart is empty.

K-Edge MTB Chain Guide for Single Ring Mountain Bike (ISCG 05 Mount)

Free shipping on orders over $29.99

$104.99

$ 46 .99 $46.99

In Stock


* Full-cage design for chain retention* Braze-on mount and braze-on adapter clamp compatible* Fully adjustable for height, center-line, and angle* Optimized for 10 and 11spd drivetrains, 34T to 44T chain ring* Compatibility: Single-ring bikes* -01: Direct mount, -02: ISCG 05


Mandingo
Reviewed in the United States on October 6, 2021
Didnt fit my 34t trek rail
Nick
Reviewed in the United States on March 24, 2020
Having put this guide though a month or so of "enduro" miles figured I would share my thoughts. My bike only has the two front mounts (sadly no rock guard mount for my 2019 Enduro) and with this being an American product I figured i'd give it a go. I originally bought a cheap (ProsAll aluminum and seems very sturdy, almost seems over built.Does well at "guiding" the chain without rubbing or interference, due in part to the adjustability.Cons:There is no installation instructions provided or that I could find online, it was pretty simple though (see below).Can be noisy with the chain hitting the cage. A little helicopter tape an remitly this for a short time, but honestly my care level is low. You will not have this problem with plastic guides.Might be a little heavier than other chain guides on the market.I honestly wish that they would install some frame spacers for further adjustment (although they are supposably available if you contact them) and also make this guide comparable with chainrings at and above the 30t mark (this is supposed to support a 34t min, however am having no problems with a 32t). That's about it.Install instructions: Install the bracket (not tight), install the large center screw (this is for in/out positioning), wrap the guide around the chain and install the small back pin (this widens the back), and install the two bolts around the center positioning bolts. Align the guide with the mounting bolts and tighten them down use the the large positioning bolt and the two other bolts to obtain a good chainline. Hopefully that makes sense.
Recommended Products