Your cart is empty.
Your cart is empty.Get loaded quicker with a Hilljak Quickie Loader. Model QL380M is designed for Smith & Wesson Bodyguard 2.0 .380ACP factory magazines. This also fits Ruger LCP 380 Max factory magazines. The ergonomic design will help save your fingers from the pain of loading and help you to load more efficiently. Spend more time practicing your shooting skills at the range and less time loading with a Quickie Loader. Designed and made in USA of durable 3D-printed biopolymer. Includes 1 year Hilljak USA warranty with free replacement. Note: This does not fit Smith & Wesson Bodyguard 1.0 models. Magazine is not included.
jim ford
Reviewed in the United States on March 12, 2025
This is a 3D printed product that i was skeptical about until i used it and found it to be very well made and it did the job it was designed to do,keep up the good work
Christine Duncan
Reviewed in the United States on February 9, 2025
Works excellent. My new bodyguard 2.0 was extremely difficult for me to load. This solved that problem.
drw
Reviewed in the United States on February 10, 2025
Difficult to use. Need to manually load first round. Next rounds don't go in easily.
Ralf
Reviewed in the United States on September 9, 2024
Sept 9, 2024. Does not work as described. The bullet doesn't remain level when the plunger pushes down on the back of the bullet. That causes the front of the bullet to pop up which blocks proper loading of the next one. It might work if the plunger depressed the middle of the bullet rather than the rear. The followers on the S&W Bodyguard 2.0 magazines are of a different design. Even if it did properly depress the bullet you also have to center the plunger each time yourself because the guides will not keep the loader centered. It's going back.
Mikey Robles
Reviewed in the United States on October 24, 2024
Great help. Works as intended
Korri
Reviewed in the United States on October 15, 2024
love it! Works great and easy to use. Shipped fast and looks great!
M. Daniel
Reviewed in the United States on October 14, 2024
Until S&W comes out with something specific to the BG 2.0, this is the best alternative I’ve found yet. The problem is the dual stack to single stack top portion of the magazines make every loaded rather loose thus far. I initially tried the LCP Max loader, which was serviceable, but required getting the loader perfectly centered for every round. Too often though, the loader would shift right or left and get caught on the sides of the magazines.This 3D printed tool works better than the LCP Max loader, but it can still shift right or left and be out of alignment and prevent a round from being pushed downward. But as tough as the magazines are to load fully, this device does save one’s fingers…especially if loading Federal Deep ammo.
Pablo B.
Reviewed in the United States on October 1, 2024
So easy to use. Excellent quality 3D print. Loaded 10 mags at the range and my fingers feel great
Recommended Products
$12.99
$ 5 .99 $5.99
$15.29
$ 6 .99 $6.99