Your cart is empty.
Your cart is empty.The TrackLock is an innovative, adaptable, T-Track table clamping solution that converts your existing bench clamps for use on T-Tracks of different sizes. The TrackLock is compatible with any brand or size of bench clamp that mounts with a 5/16" - 18 fastener. Included are four different sizes of T-Bolt fasteners to quickly convert any bench clamp from ¼" T-tracks to 13mm, 23mm, 30mm, or 35mm tracks.
John Harden
Reviewed in the United States on August 7, 2024
I have a Felder KF741 combo and this fits the slot perfectly.
Sally D.
Reviewed in the United States on May 30, 2024
But I gave it a 3 overall because the flat-head screw to attach the mounting plate was not in either package.
Eric O. DeLeon
Reviewed in the United States on February 4, 2024
Works as a very secure and quick hold down release.
Gary R Corbello
Reviewed in the United States on February 12, 2024
WORKS GREAT ON THE VISE GRIP CLAMP, EASY TO USE AND SET UP
Utah #1
Reviewed in the United States on December 10, 2024
This clamping accessory kit is as described. I am using it with the Milescraft hold down clamp in T-tracks, mainly with the larger (M8) T-bolt. The plastic cover shoe works great to allow smooth positioning of the clamp. This kit is doing just what I needed it to do to get the maximum usability from the clamp. One note - I did have to grind the sides of the larger T-bolt head just slightly to get it to fit into one of my tracks, but that is not a fault of this kit. It fit my other similar sized T-tracks just fine as-delivered.
Fuzzy Bear
Reviewed in the United States on November 11, 2024
Item as described, rec'd promptly, well packed, in new condition. Have not used it yet but expect it to work well.
Engineer
Reviewed in the United States on December 10, 2023
Good partner for the clamps, has all the needed t-bolts. T-bolts are all metric threads of different sizes.
Alex
Reviewed in the United States on September 16, 2022
the metal base is little short for 30mm t track... Maybe I wasn't looking at the the photo carefully enough to understand the exact use case for the plate.I want to use the clamp and plate on worx paegeous workbench. what I didn't expect is that the plate is only meant for using on the track, not perpendicular to the t track... as seen on photo, if perpendicular to 30mm t track, the base plate is just little short such that it fall into the track. it works ok if clamp is at an angle to track, or better yet exactly on the track. see photos.on the other hand, I can see that if I force too hard on the track perpendicularly, I can potentially pull the track off the workbench... I guess that's not the intention for both the workbench and the clamp system...
Recommended Products
