Your cart is empty.
Your cart is empty.Product Description
Javier Zamora
Reviewed in Mexico on February 4, 2025
Mi primera descripción no la envió Amazon. Falló en mi tercer extracción.
Deathknightleo
Reviewed in the United States on September 23, 2024
Like previous reviews have said bends very easy does not work
Client d'
Reviewed in Canada on May 8, 2024
J'utilise cet extracteur pour des moteurs de modelismes. Très satisfait, lesdifférentes pointes permettent de l'utiliser sur différents moteurs.Juste dommage que cela vienne en lots de 2 ...
Paul S
Reviewed in the United States on May 3, 2024
No instructions but it was not difficult to figure out how to assemble the tool. Removed a particularly stubborn pinion gear from a 180-size motor. I really like that the tool only touches the motor shaft and the bottom side of the pinion gear so the motor does not get damaged.
Customer
Reviewed in the United States on May 19, 2024
Shiny junk. Right out of the package, one of the two pieces that is supposed to slide into the main part doesn't fit, I had to use the second item. Then every single pin bent and twisted after just a quarter turn of pressure. One even snapped off inside the screw, rendering the whole assembly useless. Absolute waste of money, never even budged the tiny RC gear I was trying to remove. Even the allen key they sent bent, twisted, and broke while installing the set screw.
Steve Gribble
Reviewed in the United States on March 30, 2024
The "new" description should have contained the maximum size cog that you could straddle and remove.
Roy E Bean Jr
Reviewed in the United States on March 22, 2024
Was not able to use the top part of the tool to remove the gear, the 'feet' would not fit around the bearing housing on the front of the motor. Finally coerced it off with the help of the lower part and a different puller. Might work fine on smaller motors. The lower part is also pliable and bent.
F KIREMIDJIAN
Reviewed in the United States on February 14, 2024
I have a NEMA 17 stepping motor with a gear pressed in on the shaft. I have a collection of other pullers but none of them came close to getting the job done without risking damage to the motor. This product requires a little bit of care to set it up properly (about 5 minutes), but once set up it removed the gear effortlessly without a scratch on the motor. Very happy with the results.
Chad
Reviewed in the United States on February 10, 2024
It worked as it should to pull a press fit pi ion off of a small DC motor. Took a little bit of dexterity to get things lined up and to stay in place, but that was probably more of the fact I was doing it in my lap on the couch.
customer
Reviewed in the United Kingdom on December 8, 2024
fine
Josh Reames
Reviewed in the United States on October 11, 2024
not as bright as picth
Alan-Dale Ancheta
Reviewed in Canada on April 24, 2024
Thankfully there are two sets. Already bent the smallest punch on the first try. It did get the job done.
Francesco Bolleri
Reviewed in Italy on April 11, 2024
E' colpa mia che non ho valutato correttamente le dimensioni.Ma è troppo piccolo... io l'ho preso per togliere il giunto ad un 775, ma per questo scopo è inutilizzabile!Pazienza, lo terrò lo stesso.
Recommended Products