Your cart is empty.
Your cart is empty.Multi-functional Timer delay module is a revolutionary circuit with many commonly used timer delay functions. It is perfect for many applications from hobby to industrial controls. The timer delay module allows delaying power, disconnecting power after a preset period, cycling, and many other functions. Time delay can be set from 0.1 seconds to 400 days. The circuit is utilizing an embedded microcontroller so the time delay is precisely repeated every time. Timer functions are loaded via a separately sold programmer. The programmer can load a set of standard functions as well as custom functions created based on the specific requirements. The circuit can support up to 5 amps.
- Timer delay module can be configured to delay power, supply power for a period of time or cycle power with preset delay and etc
- Delay from 0.1 sec to 400 days
- 25+ time functions
- External trigger
- 3 - 18 Vdc
- 5 amp
- Version 8
- Easy to connect and configure
- Configurations are done via phone, tablet or laptop
- Programmer is included
- Small packaging. 28x23x9mm
- Made in USA
Moo Cow
Reviewed in the United States on October 11, 2024
Admittingly it starts out intimidating. Go to their YouTube videos, watch them a few times to understand (barely!) then just go for it. Once you get involved it starts to make sense. I got two of these programmed in about a minute of time and work perfectly. I love them. Using in a wheelchair accessible van with relays to operate the ramp system.
Tim
Reviewed in the United States on April 27, 2023
Very flexible, and relatively easy to set up.Would be nice to see a PCB version with screw terminals, and a quick disconnect for programming.Ours has been in use for a few weeks now, controlling a 12VDC doorbell in our warehouse.Some folks thought it was fun to either ring our doorbell rapidly and repeatedly,or they would just hold down the button for a few seconds at a time.Once programed, we attached it to our doorbell.Now, when people ring the doorbell, it will only ring for about 3/4 of a second,and then it will stay locked-out for 15 seconds, before anyone can push the button again.This particular mode isn't found on a lot of timers, and is working exceptionally well.
GF
Reviewed in Australia on April 12, 2021
Front door release
timc
Reviewed in the United States on November 6, 2020
I've been searching for a way to have a utility 12V outlet in my truck available while the truck is off -- but only for a while. That is, I'd like to charge my phone for an hour, but if I forget, I don't want a dead truck in the morning. I considered a DIY arduino approach but it's not that simple. And then I ran across this! Combined with an OEM dash switch and external power relay I get exactly what I want: a push of a button access to two hours of power and another tap to turn off. Shuts itself off after two hours. Perfect! After reading the fine manual and watching the videos, programming is easy -- I tried several other configurations as a test for ideas and future purchases. The unit is the size of a postage stamp in a sturdy plastic molding and has a small internal LED to indicate output state. If you need any sort of 12V power timing and logic -- this is your solution.
SK
Reviewed in Canada on October 21, 2020
A very hard to find item works great.
cfcubed
Reviewed in the United States on June 25, 2018
Working well so far. Initially used instruction video to try to program, and followed instructions precisely a few times, but program wouldn't take - It just flashed rapidly instead of programmed on/off times. After locating & performing the full reset steps in the manual the programming took.Used this for DIY under hood pest repellent, like a Rid-A-Rat on steroids, one that would for sure work. After trying everything (sonic, smells, etc) to keep squirrels from building nests under hood of a little-used truck decided to try LIGHT. Have no outside outlet near truck or might have just dropped an LED work light under hood. Needed something battery operated.Anyway this little DIY project is working to keep them away. Used this item to set about 33% duty cycle, 30 secs on 1 min off. Hooked to trunk battery through an inline fuse along with:* two 6641 White 30mm(1.23") 5050 3-SMD 12V Festoon Dome Light LED Bulbs (Amazon)* two ADJUSTABLE FESTOON BASE DOME SOCKET BULB LED UNIVERSAL HOLDERS EMPTY 31-42MM (e bay)* two Nickel (but use Quarter) Size Crystal Clear Round Coin Tubes by Whitman - Twist Off Cap (e bay). Quarter size for easier fit.* ALLPOWERS Solar Battery Maintaner 12V 18W Solar Car Boat Power Panel Charger Maintainer (Amazon) to compensate/keep battery charged.Some wire, solder + wire ties & thin foam to wrap around wire to keep it from making noise @ speed (done after photos).Might seem a bit coo-coo but if you've ever tried to keep mice, squirrels, pests from making nests under hoods of seldom used vehicles you know what I was up against:) This is working very well & unattended to keep 'em away.UPDATE (added photo w/chewed wire): Timer still great. I tried lowering duty cycle to 3 mins off/20 sec on for better solar charger/drain ratio in winter... Bad move. Squirrels are crafty and were smart enough to chew the wire to both lights. Was briefly upset but then impressed & amazed:) Think they're smarter than some coworkers of mine:)So another cleanout, repair of single truck wire they chewed, LED rewire and programing shorter duty cycle.
Dean M.
Reviewed in Canada on December 22, 2018
Takes a bit to figure out the programming. Work really well. So many different configurations possible. Very small. Great product.
=SB=
Reviewed in Canada on January 4, 2018
These are great. Does not work with a PWM signal directly. Easy to configure; Watch the youtube tutorial videos, they explain everything.
BuyerBill
Reviewed in the United States on April 15, 2018
This device will do much more than a regular time delay relay. Having been an industrial electrician familiar with and understanding complex machine controls, it has been a challenge to understand the programming of this multi-function device. The youtube videos helps and the manual will help, but understand that both are presented by a person who is very familiar with the device while skipping ahead assuming you picked up on the details . I feel that an LED light is a must have to do the programming as well as a set of switches (which both can be single pole toggle type). It should be noted that when both the green & white leads are grounded and then release, the device moves to the next sequence of programming (watch the videos carefully). Pay attention to the trigger configuration numbers. Two devices can be used together. I programmed the first device for function number 17 with a positive signal to trigger the device. Then the first device output (yellow lead) was used to provide input voltage via the red lead on the second device set to function number 3. I rate the device at 5 and the instructions at 3, overall 4.
Customer
Reviewed in Canada on May 10, 2017
This is an absolute great product easy to install and a great add on to my project I highly recommend it and the seller was also very quick with shipping. Thx.
Recommended Products
$45.00
$ 20 .99 $20.99