Your cart is empty.
Your cart is empty.Product Description
HYSHIKRA L Shape Antenna Bracket
- Mount Center of hole size :10mm ( 0.39 inches)
- Fit Standard 3/8-24 Stud connector antenna
- The bracket is made of aluminum for excellent durability and corrosion resistance
Two installation methods
- The bracket mount can install on a vertical or horizontal bar
- Can be applied to truck antenna, or outdoor antenna installation
Excellent compatibility
- Fit 3/8-24 Stud connector antenna, adapter and with UHF-female connector to connect coax cable
- Plz confirm the your accessories connetcor before purchasing
Aluminum Mount
- The whole bracket mopunt is made of aluminum, which has good durability and corrosion resistance
R. Johnson
Reviewed in the United States on April 9, 2025
I used this to mount my 1970s 1/4 wave Mobil CB antenna to my antenna mast at the house.
N
Reviewed in the United States on August 31, 2024
Hooked it up and had antana warnings and bad swr even ran a ground to the plate. The stud has insufficient insulation to be usable
Thomas
Reviewed in the United States on March 27, 2024
I had to drill out the whole for the plastic bushing to fit… I knew this before I purchased it, from the other reviewers (THANK YOU!). It works great (after being fixed with my drill). It is currently holding up a 4’ Firestik from the fascia of my house with a cookie sheet JB-welded to the front of the underside of this mount (the stud wasn’t long enough to go through the mount and cookie sheet, as I intended) as a grounding plane.
Josea
Reviewed in the United States on February 23, 2024
The hole was too small for the nylon washer so I drilled it to 1/2 in which works well.
Bob Aldridge
Reviewed in the United States on December 30, 2024
Works great
Murphy
Reviewed in the United States on January 7, 2024
The Antenna Pole Mast Mount Bracket with U-Bolts is drilled to 10mm. This size is NOT correct for the CB Adapter for 3/8-24 Stud which required a mounting hole size of 13mm or 1/2in. The smaller 10mm size will fit the adapter, however, proper clearance for the positive hot side of the antenna is to close and prone to shorting your equipment/radio.In addition, the depiction of the order for the hardware on the CB Adapter for 3/8-24 Stud is incorrect as well. It should go from top to bottom the following way. Top screw through stud, lock washer, regular washer, nylon isolation washer (which has a lip on one side to insert into the bigger 13mm or 1/2in hole), then finally the actual SO-239 with stud.FIX: drill the mounting hole to 13mm or 1/2in. and reorder the stud components to match the description.Otherwise, if your handy by all means. I will update once I test it at 100 Watts.
William Pate
Reviewed in the United States on April 27, 2024
Good quality and great service
Richard Miller
Reviewed in the United States on April 14, 2024
Quality product. As an amateur radio operator it used to hard to get the parts. Amazon makes it so easy.
Recommended Products
$29.95
$ 13 .99 $13.99