Your cart is empty.
Your cart is empty.Product Description
Compatibility:
Only used with centrifugal fan
Only replacement for brush type motors
Will not work with brushless type motor or soft/slow start motors
If the fan itself has a speed control function, using the speed controller will not work at low speeds and can only be used at high speeds.
When used at low speeds, there will be a buzzing sound, which is the electronic noise of the motor and will not affect the motor.
Switch simple easy to operate: VAR / OFF / FULL
Three settings include variable, off and on (full)
Rotary control: L / M / H
Simple use the dial to increase or decrease fan motor speed
Plug: 3-pole American(grounded)
Specification:
Current Capacity: 15A
Voltage Capacity: AC 120V
Maximum Input Power: 1500W
Note:
- Don't use on brushless type motor
- Will notwork on soft/slow start routers
Customer
Reviewed in the United States on August 11, 2024
Not applicable
roadkingmoj
Reviewed in the United States on February 15, 2024
Would not even run saw at lower speeds. Saw did not move until speed knob was at max then saw took off at max speed.
GP
Reviewed in the United States on May 1, 2023
Works great for the blower on a wood stove. Can set to any speed with this!
what's your name
Reviewed in the United States on June 6, 2022
This device only works on motors that have brushes in them, which is what it says. I put it on my 11 amp shop type vac...perfect, it dials the speed down so it's quiet and yet still allows plenty of airflow to clean. It will NOT work on any device that has soft-start technology, which the product description ALSO says and in fact you might damage a vac or power tool with soft-start if you try to use it on this device.
mitchfromnc
Reviewed in the United States on October 3, 2022
So, I had hoped to use this to slow down the RPMs on a cheap tabletop drill; however, it had no effect on the motor speed. I think I may have read somewhere that the motor had to have brushes in order for the rheostat to work properly, but I do not believe the product description was anywhere near clear enough about which applications could or could not be controlled by the unit. It did slow my shop vac down some, not a lot, but some. I'm trying to decide whether to return it or save for a DIY bee vac. I need a slower drill press, not a bee vac. :(
Too tall
Reviewed in the United States on September 28, 2021
I had a ground bee nest that was too close to the house. I needed to lower the shop vac speed to reduce the noise level at the nozzle. (Bees tend to not like noise and become “shy” of nozzle). Over a 4 day period, running at about 4 to 5 hour intervals, nest activity lowered to unsustainable volume. At that point I plugged the hole and they gave up. I’m sure I’ll find other applications for the device. I’m happy with the results.
Jersey Steve
Reviewed in the United States on August 7, 2021
I always worry about purchasing these type of devices because I can design and build them myself. I like this one. Needed something to reduce my 11amp angle grinder rpm's for buffing and polishing. It did great. Held current even when pulling the highest amps at minimum speed under heavy loads. I might buy another.
RC in NC
Reviewed in the United States on August 12, 2021
We use this to slow down a hoist designed to lift off our Jeep top. Without this speed control the hoist was too fast. This lets us lift and lower the top super slow so we can control the task alone now. When not used for the hoist I slow down the garage fan with it to a quiet gentle breeze. Great device!
Recommended Products
$11.39
$ 5 .99 $5.99