Your cart is empty.
Your cart is empty.Product Description
K
Reviewed in the United States on September 15, 2023
Good product for the price, don't forget that these will likely need a slightly higher print temp due to the lower conductivity compared to brass, but these will have a good life cycle with abrasive filaments. I use them primarily for glow-in-the-dark.
Francisco
Reviewed in the United States on December 7, 2022
The design of the nozzles are not good to use any wrench of the correct size it only has two flat sides and then it’s rounded instead of being hexagonal and that made the installation more difficult so take notice of that if you use the small wrenches and the wrench that comes with it is too big I tried utilizing it but I ended using the small ones that came with my printer they are easier and better to use unless you have palm wrench even better I would not know if these nozzle fit inside a wrench die it might or might not because of the round sides, other than that so far it fixed my clogged issue and it prints well installation was just more tricky that what it should have been
Recommended Products