Your cart is empty.
Your cart is empty.Product Description
DURA-LIFT Torsion Springs
Install new or use this left-wound torsion spring to replace broken sectional garage door torsion springs. All DURA-LIFT springs meet the DASMA standard rating of 10,000 plus door open and close cycles. Both the winding and stationary cones are professionally installed for safe operation.
Premium Product Features
Long Lasting
All DURA-LIFT springs meet the DASMA standard rating of 10,000+ door open and close cycles
Springs for Your Sectional Garage Door
Measure 20 coils to determine spring wire gauge and coil-to-coil length to determine correct replacement spring
Simple Installation
Install new or replace old, rusty springs quickly (professional installation recommended)
Product Specs
- 0.225 wire gauge
- 27" coil-to-coil length
- 1.75" inner spring diameter
- 1x left-hand wind spring included
- 2x winding bars included
Douglas Chewning
Reviewed in the United States on March 14, 2025
Quality, easy installation and performance is great. I had paid to have garage door company replace broken springs in the past for about $500. We use the garage door as our point to entrance and the door cycles probably 20+ times a day everyday. So being able to replace the springs myself is great. These springs have worked great.
Wiseguy
Reviewed in the United States on August 17, 2024
These fit perfectly and were relatively easy to install. Plus a good workout winding up the springs.
KayJazz
Reviewed in the United States on July 25, 2024
Have a metal, double garage door.These springs fit perfectly.Was a bit tedious to install, however my friend prevailed.Quality seems good.You'll need 2 - 12"+ metal rods to adjust tension.Watch some YouTube videos to get comfortable with the process.Don't forget, to use WD40 on the Hinges every couple of months for good door maintenance.
Edward Stringer
Reviewed in the United States on May 23, 2024
Quality product fit perfectly
Anthony & Family
Reviewed in the United States on March 28, 2024
easy to install, clean, no rust, and are working well for a simple uninsulated steel garage door - make sure to get the right tools (winding bars with depth indicators so you can be sure to have it well seated in the receiver holes each time you wind or unwind the coils, and make sure the coils are locked in place before unscrewing the set screws, otherwise if it slips, you could end up dead... always stand clear of the winding rods so worst case, you'll only break a hand instead of your neck... just kidding!!... well, actually, its not a laughing matter - don't try installing these unless you fully understand what you are doing, which way the coils are wound/unwound, etc.
Customer
Reviewed in the United States on November 5, 2024
works fine.
Midwest Farms
Reviewed in the United States on October 5, 2024
Just needed an inexpensive replacement for a broken spring. Worked perfect.
Slim C
Reviewed in the United States on October 17, 2024
Easy to install if your are careful enough and DIY savvy.
Recommended Products
$21.88
$ 11 .99 $11.99