Your cart is empty.
Your cart is empty.Will work with most transom mount transducers TRANSDUCER NOT INCLUDED
Blue Steel
Reviewed in the United States on February 19, 2025
Nice design! Works great on boat
Rick Nunez
Reviewed in the United States on August 5, 2024
Nice bracket set up super fast to use only issue I had where the cheap nuts and bolts that will rust , I switched over to stainless steel nuts 🔩 and bolts and lock washers
Sailor Doug
Reviewed in the United States on June 20, 2024
Well engineered and manufactured . Strong enough to do the job of keeping the transducer where it belongs without having to drill holes in your boat and easy to break it down and secure it form thieves when not in use.
timothy smith
Reviewed in the United States on May 21, 2024
A very good and durable transducer attachment, it fit perfectly for my new Garman depth finder, highly recommend
Scott
Reviewed in the United States on March 22, 2024
So much more handy than suction cup or needing to drill a hole. Well made and functional, only thing is the box for transport got blasted
Diana
Reviewed in the United States on November 20, 2024
Very good product, only two problems, screws are rusting after one time so if you get it probably try changing screws to stainless, and the other problem when you put it on top so its sometimes rubbing off the paint- no biggi but letting u knowGave it a 4 cus of screws
Ernest L.
Reviewed in the United States on April 3, 2024
Very nicely made and went on like a breeze. The only thing that I didn't like (and mentioned by a few others) is that they used cheap nuts and bolts that are prone to rust. After all, this is made for boats! At that price, the nuts and bolts should have been stainless steel. I had to replace all the hardware with stainless steel at an additional $10.
Drew
Reviewed in the United States on August 22, 2022
It comes with predrilled holes for several height adjustments. However, I had to cut off 2 inches for my application but it is easily done since it's made out of aluminum. One piece of advice I would give, is to set it at the water line on your boat. Normally I would set it even with the boat hull but when I did that the first time water was shooting straight up the square tube and coming back in the boat. Looked like a jet ski rooster tail. Raised it up to water line and down scan and side scan still work properly. Clamp is strong! Built right in my opinion.
Recommended Products
